MODEL NO. SX-NSZ4/NSZ5/NSZ7
SPEAKER DISASSEMBLY INSTRUCTIONS
Type.1Type.4
Insert a flat-bladed screwdriver into the position indicated by theTOOLS
arrows and remove the panel. Remove the screws of each speaker
unit andthen remove the speaker units.1 Plastic head hammer
2 (-) flat head screwdriver
3 Cut chisel
123
Type.2How to Remove the PANEL, FR
Remove the grill frame and four pieces of rubber caps by pulling1. Insert the (-) flat head screwdriver tip into the gap
out with a flat-bladed screwdriver. Remove the screws from holdbetween the PANEL, FR and the PANEL, SPKR. Tap
where installed rubber caps. Insert a flat-bladed screwdriver intothe head of the (-) flat head screwdriver with the plastic
the position indicated by the arrows and remove the panel. Re-hammer head, and create the clearance as shown in Fig-1.
move the screws of each speaker unit and then remove the speaker
units.2. Insert the cut chisel in the clearance, and tap the head of
the cut chisel with plastic hammer as shown in Fig-2, to
remove the PANEL, FR.
3. Place the speaker horizontally. Tap head of the cut
chisel with plastic hammer as shown in Fig-3, and
remove the PANEL, FR completely.
Type.3
Insert a flat-bladed screwdriver into the position indicated by the
arrows and remove the panel. Turn the speaker unit to counter-
clockwise direction while inserting a flat-bladed screwdriver into
one of the hollows arround speaker unit, and then remove the speaker
unit. After replacing the speaker unit, install it turnning to clock-
wise direction unitil "click" sound comes out.
Fig-1Fig-2
Fig-3
How to Attach the PANEL, FR
Attach the PANEL, FR to the PANEL, SPKR. Tap the four
corners of the PANEL, FR with the plastic hammer to fit the
PANEL, FR into the PANEL, SPKR completely.
38 |
ACEC
