Messages on the LCDProbable Cause
COVER OPENThe cover sensor detects that the top cover is not closed.
PLS CLOSE COVER
(These messages appear
alternately.)
MACHINE ERROR XX"XX" indicates an error code. Refer to [ 2 ] on pages 6-5 and
Unplug machine, then call6-6.
Brother.
(These messages appear
alternately.)
PAPER JAMPaper jam
Open cover, then remove(1) The registration sensor detects no paper within the
jammed paper.specified time length after the start of paper pulling-in.
(These messages appear(2) The registration sensor has been ON for less than the
alternately.)
specified time length (paper of approx. 3.15" long) or for
more than the specified time length (paper of approx. 16"
long).
(3) When the equipment is switched on or the top cover is
opened and then closed, the registration sensor or paper
ejection sensor is ON.
(4) The paper ejection sensor sticks to ON.
(5) The paper ejection sensor does not come ON within the
specified time length after the registration sensor has come
ON.
(6) The paper ejection sensor is kept ON after the specified
time length although the registration sensor has come ON.
PLS OPEN COVERTo display the relating detailed error code, use maintenance-
mode function code 82. (Refer to CHAPTER 5, Subsection
5.3.14.)
If this message appears, open and close the top cover. The
message may disappear if opening/closing the top cover
removes the error. If the error persists, the "MACHINE ERROR
XX" will appear.
SCANNER ERRORIn the scanning compensation data list printed by the
maintenance-mode function code 05, fifty percent or more of
the white level data is faulty.
(This message may appear only in the maintenance mode.)
6-3 |
ACEC
