2. STEREO/SAP AUTO ADJUSTMENT(S11)
Receive theZenith MTS signal of 1kHz CH.
Select the S10 of service mode to display item s, then press the CH .
Select Auto off, then execute Auto on.
Press the RECALL key of remote control to store.
Select L only or R only channel, then confirm stereo separation.
MTS READ ALR1:10h ALR2:89h
INPUT LEVEL 8
# AUTO OFF
SC0A1X16
VR 94 TZCM 1A2X 9
VL 94 LMU0AT0
GMU 0 EF0TC0
CCD 1 STS1
Move Adjust RECALL : SET
ASSEMBLY ADJUSTMENT
1. SCREEN ADJUSTMENT(S2)
Select the S2 of service mode to display item s, then press the VOL .
Adjust the Screen Volum e of FBT in order to horizontal line of screen disappear.
Press VOL of rem ote control.
2. FOCUS ADJUSTMENT(FBT FOCUS VR)
Receive the Retm a pattern.
Adjust the Focus Volume of FBT to obtain the clearest picture.
3. Geometric Adjustment(S6)
Receive the Retm a Pattern.
Select the S6 of service mode to display item s, then press the CH .
Horizontal Center Adjust.
Select H_Phase, then adjust step so that the left & right width of picture be sam e.
Vertical Center Adjust.
Select Ver_DC, then adjust V.DC so that the horizontal line of Retma Patterns center may meet with
the mechanical center of CRT.
Vertical Size Adjust.
Select V_Size, then adjust V_Size so that the center of circumference of big circle m ay meet with the
upper and lower sides of the screen.
8 |
ACEC
