IC DESCRIPTION
PinTerminalNameExplanationRemarks
26P4(7)AUDIO MUTE HConnect this port to 95 pin of ICY01.
When special play, set audio mute.
27P4(6)Not used
28P4(5)REC LED HLight up LED(RED) when recording
29P4(4)TIMER REC LED HLight up LED(GREEN) when ready to
programming record.
30P4(3)MONITOR ON HWhen CRT on, set "H".
31P4(2)VCR ON HRecording when CRT off, set "H"
32P4(1)RELAY ON HWhen CRT on, relay on during 1sec.
33P4(0)Not used
34RESETRESET(L)RESET
35P3(1)XcinIt uses 32.768KHz Crystal.
35 pin is input terminal for crystal oscillator
36P3(0)Xcout
36 pin is output terminal for crystal oscillator
37VccVccEver +5V(?0.5V). Positive power supply
38XinXinIt uses 16MHz Crystal.
38 pin is input terminal for crystal oscillator
39XoutXout
39 pin is output terminal for crystal oscillator
40VssVssGND Negative power supply.
41P2(2)OSCin3Not used
42P2(1)OSCout3Not used
43CLK SELECTWhen MICOM to start, decide to 32.768KHz or 16MHz.
Set "L" : 32.768KHz
44P2(0)OSCin2It uses LC oscillator.
Set the OSD position.
38 pin is input terminal for LC oscillator45P1(7)OSCout2
39 pin is output terminal for LC oscillator
46NUBNUBGND
47P1(6)LP HNot used
48P1(5)FSC INNot used
49VccOSD VssGND
50P1(4)CVS INNot used
51P1(3)LECHANot used
52P1(2)Not used
53VccOSD VccEver +5V (?0.5V).
54P1(1)FILTERFilter terminal for PLL.
55P1(0)SLD FILTERFilter terminal for SYNC separate.
56P0(7)C.V.S INFor Caption and Parental control signal detect.
57NUANUAGND
58P0(6)H SYNC INFor OSD horizontal SYNC input
59P0(5)V SYNC INFor OSD vertical SYNC input
11 |
ACEC
