Row 1: Paper size
NoteFor rows one to three, the page count is incremented
after every ten pages. Row four is incremented after
every end of page. Rows one to four are counted
through the engine. Rows five and six are driver
requests.
The tray count is incremented based on the tray that is
selected by the firmware, not the tray that is selected
by the user.
Media size count is incremented based on the media
size that is selected by the user. Media type count is
incremented based on 1) the media type that is
selected by the user when the media is pulled from tray
1; and 2) the media type configured on the tray when
media is pulled from tray 2 or tray 3.
Fuse mode count is incremented twice for duplexed
sheets, once when the front side is fused and once
when the back side is fused.
14 Calibration density settings? On the bottom row of text, there are four separate blocks of
numbers. The first block is for cyan, second for magenta, third for yellow, and the last is for black.
Make sure the numbers are not near zero (if so, no calibration was done).
NoteDo not print the configuration page until the printer is ready or calibration will not occur.
C7085-90921Chapter 7 Troubleshooting 289 |
ACEC
