MessageExplanation and Action
Printhead removedThe printer has detected that one or more printheads have become dislodged or
the printer cannot detect them, as indicated by the flashing squares.
Press O to continue. You should reseat the printheads immediately or replace the
ink system.
If you don't correct the error now, you will see the status message aInk
system erroro.
PrintingThe printer cannot print, because of errors previously notified.
disabledPress O to continue. Then press the Replace Ink System key to replace the
erroneous ink systems in order to print with your printer again.
Pull OYou are aligning roll media.
Align e edges to
Grasp the left and right free edges of the roll media and pull them towards you
rolluntil the media is taut. At the same time, align the left and right edges of the
media so that they are flush with the left and right edges of the roll.
Reload mediaThere was an error loading the media and the printer has ejected it. The printer is
waiting for you to reload the media.
Reload the media.
Reload sheetSheet media was loaded skewed and the printer ejected it.
Reload the sheet.
Remove allYou have selected the option Utilities / Transport mode of the front-panel
ink cartridge(s)menu, and opened the left door when instructed.
The printer is instructing you to remove all the ink cartridges.
Remove allYou have selected the option Utilities / Transport mode of the front?panel
printheadsmenu, and lifted the window when instructed.
The printer is instructing you to remove all the printheads.
Remove headYou have selected the option Utilities / Transport mode of the front?panel
cleanersmenu, and opened the right door when instructed.
Close right doorThe printer is instructing you to remove all the printhead cleaners, and then close
the right door.
Remove mediaThe ink is dry.
Remove the accuracy calibration print that has just been produced.
Press O to continue with accuracy calibration.
Remove mediaAn attempt to load media was made while the media lever was lowered.
Lift lever
Remove the media, lift the lever, and reload media with the lever up.
3-12HP DesignJet CP Series PrintersUser Messages |