MessageExplanation and Action
Ink cartridge valveThe printer has detected that one or more of the ink cartridge valves (as indicated
out by flashing squares) has popped out during refilling.
Press O to check the failing ink cartridge. You should reseat the valves
immediately. If this does not solve the problem, you will have to replace
the entire ink system (printhead, printhead cleaner, and ink cartridge)
using the Replace Ink System key.
Ink system at end ofThe printer has found that an earlier aOut of inko error has not been
life corrected. One or more components of the ink system, as indicated by
flashing squares, have reached the end of their intended lives. You should
now replace all three components of those ink systems affected (the
printheads, the printhead cleaners and the ink cartridges).
Press O to continue. Image print quality may be affected. Replacement of
the ink systems affected is recommended.
Ink system at end ofThe printer has detected that one or more components of the ink system have
life. Retryreached the end of their intended lives. You should now replace all three
components of those ink systems affected (the printheads, the printhead
cleaners and the ink cartridges).
Press O to replace the erroneous ink systems.
INK SYSTEMThe printer has detected an error in the ink system, as shown in earlier messages.
ERRORPrinting will be disabled until the error has been corrected. If more than one error
xx-xxxx is pending, the one with the highest number, corresponding to the most severe
error, will be displayed.
Possible error codes (xx-xxxx) are:
w 58.... See the message aIncorrect ink systemo
w 65.... or 66.... See the message aPrinthead failureo
w 67.... See the message aPrinthead contact erroro
w 72.... See the message aInk cartridge removedo
w 73.... See the message aHead cleaner removedo
w 74.... See the message aPrinthead removedo
w 88.... See the message aMixed ink systemo.
Press the Replace Ink System key to replace the erroneous ink systems in order
to print with your printer again.
Press the Enter key to access the main front panel menus.
FOR FURTHER INFORMATION REFER TO INK SYSTEM ERROR
XX-YYYY IN CHAPTER 2.
Install completeInk system replacement has been completed successfully.
Resume normal operations.
3-6HP DesignJet CP Series PrintersUser Messages |
ACEC
