42PD4200 (PW1A)
2
ItemVideo Color Temperature Adjustment (Normal)Adj. pointIC
Adjustment PreparationsAdjustment ProceduresRemarks
(1) Set the output of signal (1)Perform the following adjustment with Color temperature should
generator to white raster.the remote control.be adjusted under the
(Ratio : 100%)condition in which the screen
is the brightest, thus the
initial value of adjustment is
it?s maximum value.
(2) Component signal (480i)(2)Set the CRT color analyzer (CA100) Only reducing the brightness
Video level : 0.714Vp-pat the center of the panel.controls the adjustment, thus
SYNC : 0.286Vp-pweaken the brighter color to
Set-up level : 0Vadjust.
(3) Set Picture MENU to(3)Ensure that adjustment No. 3, 4, 5
[RESET] are all set as 224.
(4) Set into Factory adjustment (4)After receiving Video signal, step Color temperature is at
mode.down the two (or one) among Normal mode while the
adjustment No. 3, 4, 5 and adjust following No. is selected.
the value as shown below.
Adjustment No. 03, 04, 05
At least one of the data should be 224.
< Specification >
Video color temperature (Normal)
x=0.2850.005
y=0.2930.005
(Color Temp:9300K0MPCD)
22 |
ACEC
