DW2U
5.3 VIDEO COLOR TEMPERATURE ADJUSTMENT6.DIGITAL MAIN CHECK
(STD)
Preparation
6.1SYSTEMSOFTWAREVERSION CHECK
(1) Same as ?Video Color Temperature adjustment:
(HIGH)?. For 55? video level changes to 0.700Vp-p.
(1) Press Menu button on the R/C or control
panel.
Adjustment
(2) Enter the SETUP options, and then look
(1) Perform the following adjustment with the remote
for UPGRADES option.
control.
(2) Set the CRT color analyzer (CA-100) at the center of(3) The Main software version will be display
the panel.V0100.0000 as shown on Fig. 1.
(3) Set color temperature to ?STD?.(4) If this version needs to be change for a
(4) Ensure that Adjustment R/G/B DRIVE (STD) are alldesign improvement or failure, please
set as FF.select the Upgrade Now button.
(5) After receiving White raster signal, step down the two
(or one) among Adjustment R/B/G DRIVE (STD) andFig. 1Software version
adjust the value shown below.
Setup
Specification
Reset The Software
Video Color temperature (STD)ORSoftware Version # : Main Vxxxx.xxxx
MMC Software Upgrade
42" Upgrade Now
x = 0.314 ? 0.005Please Insert MMC card before upgrading.
y = 0.327 ? 0.005Reset TV Settings
No Yes
(Color temp: 6500K )Please In(Seselecrt "tY MMes" toCc retuarnr adll settings to the factory
default after main power OFF/ON.)
55" MoveSEL Return
oveReturn
x = 0.314 ? 0.005
y = 0.327 ? 0.005
(Color temp: 6500K )
(5) The upgrading process begin by filling a
bar, when finish the message will say,
At least one of the data should be FF.
?Upgrade complete ?? when this appear
5.4 VIDEO COLOR TEMPERATURE ADJUSTMENTunplug the TV from the AC line outlet to
(B/W) (Only for HDX models) complete the process.
Preparation(6) Now plug again the TV and verify the
(1) Same as ?Video Color Temperature adjustment:new software version.
(HIGH)?. For 55? video level changes to 0.700Vp-p.
(7) The Main software version will display the
Adjustmentlatest version issue by design.
(1) Perform the following adjustment with the remote
control.NOTE:
(2) Set the CRT color analyzer (CA-100) at the center of
the panel.(1) A Service Bulletin will be sent when a
(3) Ensure that Adjustment R/G/B DRIVE (B/W) are allnew version is issued officially to the
set as FF.
Service Department every time the soft-
(4) After receiving White Raster signal, step down the
ware version needs to be modified.
two (or one) among Adjustment R/B/G DRIVE (B/W)
(2) In case that the upgrade fails or when a
and adjust the value shown below.
CARD is inserted with new version and
Specificationcan?t upgrade ; please perform the
Video Color temperature (B/W)FACTORY RESET process to the TV,
then try upgrading again.
42"
x = 0.335 ? 0.005
y = 0.343 ? 0.005
(Color temp: 5400K )
55"
x = 0.335 ? 0.005
y = 0.343 ? 0.005
(Color temp: 5400K )
At least one of the data should be FF.
Remarks
(1) Same as ?Video Color Temperature adjustment
(HIGH)?
43
BACK TO ADJUSTMENTS |
ACEC
