1. DISPLAY ALIGNMENT
A. Times & Display Size
For all presetting mode listing in section 2.4 shall be within the limitation:
H. WIDTH 306 ? 4 mm
V. HEIGHT 230 ? 4 mm
The external control range of the data area, shall be as follows;
Max. horizontal size : overscan the screen
Min. horizontal size : d 285mm
Max. vertical size : over the screen
Min. vertical size : d 202 mm
B. Picture Position
For all presetting mode listing in section 2.4 shall be within the limitation:
H.PHASE SCREEN CENTER ? 3 mm
V.CENTER SCREEN CENTER ? 3 mm
The external control ranges of display for all modes listed in section 2.4
H.POSITION e 50 mm
V.CENTER e 25 mm
C. Linearity
The CONTRAST and BRIGHTNESS control shall be properly adjusted at 20 F-L with Full-intensity reverse
pattern, then change to crosshatch Pattern 12x10 (H x V), the size of grid of crosshatch pattern in every display
mode shall not vary than 10%. If two line is next to each other, 5% if they are not next to each other. The calculation
formula was listed below:
H max - H min V max - V min
x 100% or x 100%
(H max + H min) / 2 (V max + V min) / 2
1 |
ACEC
