DCR600II
AT27LV010A
Block DiagramAbsolute Maximum Ratings*
Temperature Under Bias .................. -40°C to +85°C
Storage Temperature...................... -65°C to +125°C
Voltage on Any Pin with
(1)
Respect to Ground......................... -2.0V to +7.0V
Voltage on A9 with
(1)
Respect to Ground ...................... -2.0V to +14.0V
VPP Supply Voltage with
(1)
Respect to Ground....................... -2.0V to +14.0V
*NOTICE: Stresses beyond those listed under ?Absolute Maxi-
mum Ratings? may cause permanent damage to the device.
This is a stress rating only and functional operation of the
device at these or any other conditions beyond those indi-
cated in the operational sections of this specification is not
implied. Exposure to absolute maximum rating conditions
for extended periods may affect device reliability.
Note: 1. Minimum voltage is -0.6V dc which may undershoot to -
2.0V for pulses of less than 20 ns. Maximum output
pin voltage CCis V+ 0.75V dc which may be ex-
ceeded if certain precautions are observed (consult
application notes) and which may overshoot to +7.0
volts for pulses of less than 20 ns.
Operating Modes
Mode \ PinCEOEPGMAiVPPVCCOutputs
(2) (1)(2)
ReadVILVIL XAiXVCC DOUT
(2)(2)
Output DisableXVIHXXXVCC High Z
(2)(2)
Standby VIHXXXXVCC High Z
(3)(3)
Rapid ProgramVILVIHVILAiVPPVCC DIN
(3)(3)
PGM Verify VILVILVIHAiVPPVCC DOUT
(3)(3)
PGM Inhibit VIHXXXVPPVCC High Z
(4)
A9 = VH
(3, 5)(3)Identification
Product Identification VILVILXA0 = VIH or VIL XVCC
Code
A1 - A16 =IL V
Notes: 1. X can ILb or Ve VIH.4. VH = 12.0? 0. 5V.
2. Read, output disable, and standby modes re5.qu iTrweo, id entifier bytes may be selected. All Ai inputs are held
3.0V L VCC L 3.6V, or 4.L 5V VCC L 5.5V.low (VIL), except A9 which is sH anet td A0 whio Vch is tog-
3. Refer to Programming Characteristics. Programmgleidn lgow IL(V) to select the Manufacturer?s Identification byte
modes requireCC V = 6.5V.and high (IH) toV select the Device Code byte.
76 |
ACEC
