1,2. Alignment tape1.3 DISASSEMBLY/ASSEMBLY OF CABINET PARTS
To be used for check and adjustment of interchange-
ability of the mechanism.1.3.1 Disassembly flow chart
(Video: Color bar signal, Audio: Non-signal)This flowchart indicates the disassembly step for the cabi-
net parts and board assembly in order to gain access to
3. Torque driveritem(s) to be serviced. When reassembling, perform the
Be sure to use to fastening the mechanism and exte-step(s) in reverse order. Bend, route and dress the flat ca-
rior parts because those parts must strictly be control-bles as they were originally.
led for tightening torque.
1Cassette cover assembly
4. Bit
This bit is slightly longer than those set in conventional
torque drivers.Upper case2
5. INF adjustment lensLower case assembly
To be used for adjustment of the camera system.
(Incl. E.VF assembly)3
6. Conn. ring
The connector ring to attach the INF. lens to the head
of the OP lens.4E.VF assembly
7. Gray scale chartTop operation unit
5
To be used for adjustment of the camera system.
8. Color bar chartRear unit6
To be used for adjustment of the camera system.
Front cover assembly
9. INF lens holder7
To be used together with the camera stand (11) for op-(Incl. Microphone / DC light assembly)
erating the VideoMovie in the stripped-down condition
such as the status without the exterior parts or for us-
Microphone
ing commodities that are not yet conformable to the in-8
terchangeable ring.
9DC light assembly / Cover(light)
10. Light box assembly
To be used for adjustment of the camera system.
Monitor assembly
0
11. Camera stand
To be used together with the INF adjustment lens
holder.!Front frame assembly
12. Extention connectorNOTE :For screw management, refer to the table appear-
To be used to JIG connector cable
ing in the section O1.9 SERVICE NOTE� (page 1-
13. JIG connector cable16).
Connected to CN25 of the main board and used for
measuring error rates, etc.
14. Communication Cable
Connect the Communication cable between the PC ca-
ble and Jig connector cable when performing a PC ad-
justment.
15. Service support system
To be used for adjustment with a personal computer.
16. PC cable
To be used to connect the VideoMovie and a personal
computer with each other when a personal computer
isused for adjustment.
17. Cleaning cloth
Recommended cleaning cloth to wipe down the video
heads, mechanism (tape transport system), optical lens
surface.
1-3 |