AV14BJ8ENS / AV14BM8ENS
AV14BJ8EPS / AV14BM8EPS
AV14BJ8EES / AV14BM8EES
DISASSEMBLY PROCEDURE
AV14BM8ENS / EPS / EES
REMOVING THE REAR COVER
1. Unplug the power cord.
2. Remove the 4 screws marked A as shown in the Fig. 2.
3. Withdraw the rear cover toward you.
REMOVING THE MAIN PWB
" Removing the REAR COVER.
1. Slightly raise the both sides of the chassis by hand and
withdraw the MAIN PWB.
(If necessary, take off the wire clamp, connectors etc.)
REMOVING THE FRONT AV JACK PWB
" Removing the REAR COVER.
" Remove the MAIN PWB.
1. Remove the 2 screws marked B.
2. Remove the FRONT AV JACK PWB.
REMOVING THE HP JACK BOARD
" Removing the REAR COVER.
" Removing the MAIN PWB
1. Remove the 1 screws marked C.
2. Remove the HP JACK PWB.
CHECKING THE PW BOARD
To check the back side of the PW Board.
1) Pull out the PW Board. (Refer to REMOVING THE MAIN
PWB).
2) Erect the PW Board vertically so that you can easily check
the back side of the PW Board.
[CAUTION]
" When erecting the PW Board, be careful so that there will be no
contacting with other PW Board.
" Before turning on power, make sure that the wire connector is
properly connected.
" When conducting a check with power supplied, be sure to confirm
that the CRT EARTH WIRE (BRAIDED ASS?Y) is connected to
the CRT SOCKET PW board.
WIRE CLAMPING AND CABLE TYING
1. Be sure to clamp the wire.
2. Never remove the cable tie used for tying the wires together.
Should it be inadvertently removed, be sure to tie the wires with
a new cable tie.
8No.51999 |
ACEC
