AV-14F703
SPECIFIC SERVICE INSTRUCTIONS
DISASSEMBLY INSTRUCTIONS
1. REMOVAL OF ANODE CAP3. After one side is removed, pull in the opposite direction to
Read the following NOTED items before starting work.remove the other.
NOTE
* After turning the power off there might still be a potential
voltage that is very dangerous. When removing theTake care not to damage the Rubber Cap.
Anode Cap, make sure to discharge the Anode Cap's
INSTALLATION
potential voltage.
* Do not use pliers to loosen or tighten the Anode Cap1. Clean the spot where the cap was located with a small
terminal, this may cause the spring to be damaged.amount of alcohol. (Refer to Fig. 1-3.)
NOTE
REMOVAL
Confirm that there is no dirt, dust, etc. at the spot where
1. Follow the steps as follows to discharge the Anode Cap.the cap was located.
(Refer to Fig. 1-1.)
Connect one end of an Alligator Clip to the metal part of a
flat-blade screwdriver and the other end to ground.
While holding the plastic part of the insulated Screwdriver,Location of Anode Cap
touch the support of the Anode with the tip of the
Screwdriver.
A cracking noise will be heard as the voltage is discharged.
GND on the CRT
Fig. 1-3
2.Arrange the wire of the Anode Cap and make sure the
wire is not twisted.
3.Turn over the Rubber Cap. (Refer to Fig. 1-4.)
CRT
Screwdriver
Support
Alligator Clip
GND on the CRTFig. 1-4
Fig. 1-1
4. Insert one end of the Anode Support into the anode
2. Flip up the sides of the Rubber Cap in the direction of the
button, then the other as shown in Fig. 1-5.
arrow and remove one side of the support.
(Refer to Fig. 1-2.)
Rubber Cap
Support
CRTCRT
SupportFig. 1-5
Fig. 1-2
5.Confirm that the Support is securely connected.
6.Put on the Rubber Cap without moving any parts.
4No. 52002 |
ACEC
