AV-21F9
3. BASIC OPERATION IN SERVICE MENUSERVICE MENU
(1) How to enter SERVICE MENU
Press the DISPLAY key and the PICTURE MODE key onSERVICE MENU
the remote control unit simultaneously.
1. IF2. V/C 3. AUDIO
The SERVICE MENU screen will be displayed. (See Fig. 1.)4. DEF5. VSM PRESET
6. CENTER
7. TURBO TIMER OFF
1-7 : SELECTDISP : EXIT
]]]]]]]] ]]]]]]].]]]]
]]] ]]]]]]].]]]]
Fig. 1
(2) Selection of SUB MENU SCREEN
Press one of the keys 1 ~ 7 on the remote control unit, and select the SUB MENU SCREEN from the SERVICE MENU. (See Fig. 2 on
the next page.)
SERVICE MENU ? SUB MENU1. IF
2. V / C
3. AUDIO
4. DEF
5. VSM PRESET
6. CENTER
7. TURBO TIMER
(3) Method of Setting
*Once the setting values are set, they are memorized automatically.
*It must not adjust without inputting a signal.
1) 1. IF
[1. VCO]
(a) 1 Key .........................................1. IF.Select
(b) 1 Key ......................................... Select 1. VCO. (CW)
(c) VCO(CW) TRANSF. .................. Adjust VCO(CW) while watching the colour (yellow/blue) of the characters on the screen.
(d) DISPLAY Key ............................ When this is pressed twice, you will return to the SERVICE MENU.
[2. DELAY POINT]
(a) 1 Key .........................................1. IF.Select
(b) 2 Key ......................................... Select 2. DELAY POINT.
(c) MENU - / + Key......................... Adjust the setting value.
(d) DISPLAY Key ............................ When this is pressed twice, you will return to the SERVICE MENU.
2) 2. V/C, 3. AUDIO, 4. DEF, 5. VSM PRESET and 6. CENTER
(a) 2 ~ 6 Keys .................................2. V/C, 3. Select one from AUDIO, 4. DEF, 5. VSM PRESET and 6. CENTER.
(b) MENU a key........................ Select setting items.
(c) MENU - / + Key......................... Adjust the setting values of the setting items.
l Use the number keys on the remote control unit for setting of WHITE BALANCE and BLACK
OFFSET. For the setting, refer to each item concerned.
(d) DISPLAY Key ............................ When this is pressed, you will return to the SERVICE MENU.
3) 7. TURBO TIMER
(a) 7 Key ......................................... Each time you press the key, ON/OFF state of TURBO TIMER changes.
(Should be set to OFF.)
(4) Release of SERVICE MENU
After completing the setting, return to the SERVICE MENU by pressing the DISPLAY key, then again press the DISPLAnY key to retur
to the normal screen.
No. 5603711 |
ACEC
