AV32L2EUGR
AV32L2EUBL
AV32L2EUGY
REPLACEMENT OF MEMORY ICs
1. Memory ICs
This TV use memory ICs. In the memory ICs, there are memorized data
for correctly operating the video and deflection circuits. When replacing
memory ICs, be sure to use ICs written with the initial values of data.SERVICE MENU
1. IF2. V/C
3. AUDIO4. DEF
2. Procedure for replacing memory ICs5. VSM PRESET6. STATUS
7. PIP8.
PROCEDURE9. SHIPPING (OFF) 0. BUS FREE
1-9 : SELECT i : EXIT
(1) Power off
Switch the power off and unplug the power cord from the wall outlet.
Fig.1
(2) Replace ICs.
Be sure to use memory ICs written with the initial data values.
SYSTEM CONSTANT SET
1. DESTINATION EU
(3) Power on
Plug the power cord into the wall outlet and switch the power on.
+OK : STOREi : EXIT
(4) Check and set SYSTEM CONSTANT SET:
**** It must not adjust without signal.
Fig.2
1) Press the INFORMATION key and the MUTING key of the
REMOTE CONTROL UNIT simultaneously.
2) The SERVICE MENU screen of Fig. 1 will be displayed.
2. CRT TYPE 16 : 9
3) While the SERVICE MENU is displayed, press the3. PURITY NO
4. PICTURE TILT YES
INFORMATION key and MUTING key simultaneously, and the
5. DIGIPURE PRO YES
SYSTEM CONSTANT SET screen of Fig. 2 will be displayed.6. PIP NO
7. PIC & TEXT YES
4) Check the setting values of the SYSTEM CONSTANT SET of
8. DOLBY NO
Table 1. If the value is different, select the setting item with the9. BBE YES
10. PROGRESSIVE YES
FUNCTION UP/DOWN key, and set the correct value with the
11. TDA9178 YES
FUNCTION -/+ key.12. TONE IC NO
13. FLAT YES
5) Press the MENU(OK) key to memorize the setting value.
6) Press the INFORMATION key twice, and return to the normal
screen.
NAME OF REMOTE CONTROL KEY
(5) Setting of receive channels
Names of keykey
Set the receive channel.
For setting, refer to the OPERATING INSTRUCTIONS.
INFORMATIONiiii
(6) Setting of SERVICE MENU
MUTING
Verify the setting items of the SERVICE MENU of Table 2, and reset
where necessary.
For setting, refer to the SERVICE ADJUSTMENTS.MENUOK
1
(7) User settings
FUNCTION UP/DOWN
Check the user setting values of Table 3, and if setting value is1
different, set the correct value.
For setting, refer to the OPERATING INSTRUCTIONS.1
FUNCTION -/+1
+
TVTV
No. 518179 |
ACEC
