4.6.1 TOOL OF SERVICE MODE OPERATION
Operate the SERVICE MODE with the REMOTE CONTROL UNIT.
4.6.2 SERVICE MODE ITEMS
In general, basic setting (adjustments) items or verifications are performed in the SERVICE MODE.
1.PICTURE/SOUNDThis sets the setting values of the Video / Audio / Defrection circuits.
2.YC SEPThis is used when the YC separation circuit is adjusted. [Do not adjust]
3.WHITE BALANCEThis sets the setting values of the WHITE BALANCE.
4.MEMORY SETUPThis sets the setting values of the MEMORY ADDRESS. [Do not adjust]
5.RF AFCThis is used when the IF VCO is adjusted. [Do not adjust]
8.IPThis sets the setting value of the DIST circuit. [Do not adjust]
9.DSDThis sets the setting value of the DSD (Digital super detail) circuit. [Do not adjust]
0.HDMIThis sets the setting value of the Digital input circuit. [Do not adjust].
4.6.3 HOW TO ENTER THE SERVICE MODE
(1) Set the SLLEP TIMER to 0 minutes using the [SLEEP
SERVICE MODE SELECT KEY
TIMER] key.
(2) Press the [VIDEO STATUS] key and [DISPLAY] keyVCR/DVD
simultaneously, then enter the SERVICE MODE mode.switch
(3) When the main menu is displayed, press any key of the [0]
TV/CATVPOWER
to [9] key to enter the corresponding sub menu mode.
switch
NOTE:
Before entering the SERVICE MODE, confirm that the settingDISPLAY
NUMBER
of TV / CATV switch of the REMOTE CONTROL UNIT is at the
SLEEP
"TV" side and the setting of VCR / DVD switch is at the "VCR"TIMER
side. If the switches have not been properly set, you cannot
enter the SERVICE MODE.VIDEO
STATUS
CH +
4.6.4 HOW TO STORE OF SETTING VALUE
When adjustment is completed, press the [MUTING] key to
VOL +
memorize the adjustment value. If not to do it, adjustment data is
not memorized to the memory IC. And if exit the adjustmentVOL -
BACK
mode before memorize the data, the adjustment value which you
change is canceled.MENUCH -
4.6.5 HOW TO EXIT THE SERVICE MODE
Press the [BACK] key to exit the SERVICE MODE.
RM-C1257G
1-18 (No.YA093) |
ACEC
