AV-4300
AV-5000
1.5 SECAM White Balance Adjustment1.6 Comb Filter Operation Check
Adjustment PreparationAdjustment Preparation
1. SECAM BELL FILTER adjustment should be finished.1. Receive the PAL Philips pattern signal.
2. Receive the SECAM Philips pattern signal or color bar2. Select the PICTURE option using ['] button.
signal.3. Select PERSONAL [SET UP] option using ['] button.
3. Connect the probe to C536 (R-Y). C537 (B-Y) at Signal Sub4. Select the COMB FILTER mode by pressing [%] / [$]
P.W.B (Refer to figure below).button.
4. Set to "CSYS" DATA: 06, "TVSW" DATA: 05, "CTRA"Adjustment Procedure
2
DATA: 01, "15SW" DATA: 00 of V/C IC ADJUST MODE.1. Set the COMB FILTER : ON by pressing ['] button, and
check the COMB FILTER operation as shown in the figure
below.
line dots : a little
PAL (Philips pattern)
NON CROSS COLOR
Adjustment Procedure
2. Set the COMB FILTER : OFF by pressing ['] button, and
1. Adjustment signal level as shown below by "RADJ" "BADJ"
check the COMB FILTER operation as shown in the figure
2
of V/C I C ADJUST MODE.
below.
* REMARK
2
After Adjustment (1.5 and 1.6) IC DATA Reset.
"CSYS" : 06 ???? 03
"TVSW" : 05 ???? 03
"CTRA" : 01 ???? 00
"15SW" : 00 ???? 01
No. 5187621 |
ACEC
