AV-N29302
SPECIFIC SERVICE INSTRUCTIONS
DISASSEMBLY PROCEDURE
REMOVING THE REAR COVERCHECKING THE PW BOARD
1. Disconnect the power plug from wall outlet.To check the PW Board from back side.
2. As shown in the Fig.1, remove the 11 screws marked !!!!.1. Pull out the chassis (refer to REMOVING THE CHASSIS).
2. Erect the chassis vertically so that you can easily check the back
3. As shown in Fig.1, remove the 4 screws marked """".
4. Then remove the REAR COVER toward you.side of the PW Board.
CAUTION
REMOVING THE CHASSIS" When erecting the chassis, be careful so that there will be no
" After removing the REAR COVER.
1. Slightly raise the both sides of the chassis by hand and remove thecontacting with other PW Board.
" Before turning on power, make sure that the wire connector is
two claws under the both sides of the chassis from the frontproperly connected.
cabinet." When conducting a check with power supplied, be sure to
2. Withdraw the chassis backward.
(If necessary, remove the wire clamp, connectors etc.)confirm that the CRT EARTH WIRE (BRAIDED ASSY) is
connected to the CRT SOCKET PW board.
REMOVING THE SPEAKERWIRE CLAMPING AND CABLE TYING
" After removing the rear cover.
1. Be sure to clamp the wire.
1. As shown in Fig. 1, removing the 2 screws marked ####, then2. Never remove the cable tie used for tying the wires together.
remove the speaker.Should it be inadvertently removed, be sure to tie the wires with a
2. Follow the same steps when removing the other hand speaker.new cable tie.
NOTE : When removing the screws marked #### of the speaker,
remove the lower side screw first, and then remove the
upper one.
No.51834 6 |
ACEC
