SECTION 3
DISASSEMBLY
3.1 Main body section
3.1.1 Remove the top cover (See figure 1)
(1) Remove the four screws A attaching the top cover on bothB
sides of the main body.
(2) Remove the five screws B attaching the top cover on theTTTOP COOOP COP COVERVVERER
back of the main body.
(3) Raise the both sides and lower part of the rear of the topB
cover, with opening them slightly in an outward direction.A x 2
B
And the top cover will be removed.
B
A x 2
B
Fig.1
3.1.2 Remove the front panel assembly (See figure2, figure 3, and figure 4)
? Prior to performing the following procedure, remove the top
Hook a
cover.
? There is no need to remove the mechanism assembly.
(1) Disconnect the card wires from connector CN3001,
CN3002, CN4001 on the main board.
Front panel
(2) Hooks a and b are removed respectively, and the frontassembly
panel assembly is removed.
NOTE:
In case of attach a front panel assembly, please let a
card wire pass in the hole in the front part of a chassis,
respectively, and connect.
HHook book b
CN4001 CN3002CN3001
Hook a
Fig.3
Chassis of front part
Main board
Fig.2
Card wireCard wireCard wire
Front panel
assembly
Fig.4
(No.XA019)1-7 |
ACEC
