1.6 TAKE OUT CASSETTE TAPE
In the event that the set enters the emergency mode as it5. For taking in the slack of the tape, run the mechanism
is loaded with a cassette tape and the cassette tape can-to the EJECT position as the front lid of the cassette is
not be ejected with the EJECT button, manually, take it outleft open, and turn the take-up gear in the forward di-
of the set according to the following procedure.rection to wind up the tape. After confirming that the tape
Note:has completely been wound up and the supply reel is
YIf the mechanism comes into the unloading mode as theidling, take the cassette tape out of the cassette hous-
cassette tape is not held by hand, it results in tape dam-ing.
age.
1. Disconnect the set from the power source.
2. Remove the cassette cover assembly, Upper case,
Lower case assembly, Top operation unit, Front cover
assembly (See Fig. C1, C2, C3, C5 and C7, Pages 1-4
to 1-6).
3. Connect a jumper wire to each pole of the loading mo-
tor as shown by the magnified view (Fig. 1-6-1)
4. While holding down the cassette housing by hand, con-
nect the jumper wires to a battery to run the mechanism
to the EJECT position four unloading. If this unloading
operation is performed as the cassette housing is not
held down by hand, the front lid of the cassette may
damage the tape when it is ejected.
BATTERY
TOP VIEW
MAGNIFIED VIEW b
TAKE-UP GEAR
Fig. 1-6-1
1-11 |
ACEC
