? Chip IC replacement jig4.2 JIG CONNECTOR CABLE CONNECTION
To be used for adjustment of the camera system.
? Connection procedure
? Cleaning cloth
Recommended the Cleaning cloth to wipe down the video
heads, mechanism (tape transport system), optical lens sur-
face.
? Guide driver (Hexagonal)
To be used to turn the guide roller to adjustment of the linarity
of playback envelope.
? INF adjustment lens
To be used for adjustment of the camera system. For theGUIDE ROLLER (TU)
usage of the INF adjustment lens, refer to the Service Bulletin
No. YA-SB-10035.
? INF adjustment lens holderCOVER(ADJ)
To be used together with the Camera stand for operating the
Videocamera in the stripped-down condition such as the sta-
tus without the exterior parts or for using commodities that are
not yet conformable to the interchangeable ring. For the usage
of the INF lens holder, refer to the Service Bulletin No. YA-SB-GUIDE ROLLER (SUP)
10035.
? Camera stand
To be used together with the INF adjustment lens holder. For
the usage of the Camera stand, refer to the Service Bulletin
No. YA-SB-10035.
? Light box assembly
To be used for adjustment of the camera system. For the
usage of the Light box assembly, refer to the Service Bulletin
No. YA-SB-10035.
? Gray scale chartJIG CONNECTOR
To be used for adjustment of the camera system. For the
usage of the INF adjustment lens, refer to the Service BulletinCOVER(JIG CON)
No. YA-SB-10035.EXTENSION
CONNECTOR
YTU94145E-40SERVICE SUPPORT SYSTEM
? Color bar chart
YTU94145D-40
To be used for adjustment of the camera system. For the
usage of the INF adjustment lens, refer to the Service Bulletin
No. YA-SB-10035.
RS232C
? Alignment tapeJIG CONNECTORCOM PORTMENU
CABLE
To be used for check and adjustment of interchangeability ofPC CABLE
the mechanism.
COMMUNICATION CABLE
? PC cable
FOR
To be used to connect the Videocamera and a personal computerCOMMUNICATION CABLEPERSONAL COMPUTER
with each other when a personal computer issued for adjustment.
? Communication cableJIG CONNECTORCOMMUNICATION CABLEJIG CONNECTOROSCILLOSCOPE
RED
Connect the Communication cable between the PC cable andTO JLIP_RX
Jig connector cable when performing a PC adjustment.WHITETO ENV_OUT
TO JLIP_TX
BLACKTO HID
? Service support systemTO GND
To be used for adjustment with a personal computer. Software
can be downloaded also from JS-net.
Fig.4-2-1
? Jig connector cable
Connected to JIG CONNECTOR of the main board and used
for electrical adjustment, etc.
? Extension connector
Connect this extension connector to the connector of the Jig
connector cable for extending the cable connector.
1-16 (No.YF075) |
ACEC
