2.1.6 CHECKUP AND ADJUSTMENT OF MECHANISM PHASE
[24]MODE GEAR[27]ROTARY ENCODER
Align the MODE GEAR with the Main Deck Mount the ROTARY ENCODER by aligning its mark ( )
Assembly hole.and the mark ( ) of the Main Deck Assembly.
Note:Note:
The MODE GEAR may Be careful when handling the FPC during mounting.
be displaced during the
mechanism operation,
however it can be
checked from the rear
and realigned during
manual assembly.
[34]REEL GEAR 1
Align the REEL GEAR 1 with
the Main Deck Assembly hole.
Note:
The REEL GEAR 1 may be
displaced during mechanism
operation, however this can
be checked fr om the rear and
realigned during manual
assembly.
[29]MAIN CAM ASSY/[30]SLIDE ARM ASSY [32]SUB CAM ASSY/[33] CONTROL ARM ASSY
When mounting the SLIDE ARM ASSY align it with the Mount the SUB CAM ASSY hole to align with the CONTROL
Main Deck Assembly and MAIN CAM ASSY holes.ARM ASSY and Main Deck Assembly holes and then tighten
Note:them all together with a screw.
During the mounting procedure, make sure that the[32] Note:
SUB CAM ASSY is in the correct mounting position.When mounting it, make sure that the[29]MAIN CAM ASSY is
in the correct mounting position.
Fig.2-1-25
2-14 (No.86700) |