5.2 TAKE OUT CASSETTE TAPE
(1) Remove the Power Unit (battery or DC code) from the set.(DC3V)
(2) Remove 1 screw, and remove a plate (ADJ).CASSETTE COVER
NOTE:
For more efficient operation, loosen and move the grip
belt prior to the procedure (2).
(3) Open the CASSETTE COVER till it is completely opened
and fixed.
(4) Attach a PVC tape as shown in the figure.
NOTE:
Be careful of cassette tape damage caused because the
TAPE
CASSETTE HOUSING ASSEMBLY is moved upward at
the unloading end (EJECT mode).
LOADING MOTOR
(5) To set the SLIDE DECK ASSEMBLY to the unloading end,ASSEMBLYCASSETTE HOUSING
apply DC 3V to the electrode (terminal) on the top surfaceASSEMBLY
of the LOADING MOTOR ASSEMBLY that is seen through
a hole under the plate removed in the procedure (2).REEL DISK
ASSEMBLY (SUP)
NOTE:
Be careful not to attach grease or a similar substance toSLIDE DECK
the surface of the cassette tape on the tape transportASSEMBLY
system.
(6) Wind the cassette tape by directly turning the REEL DISK
ASSEMBLY (SUP) from the backside of the SLIDE DECK
ASSEMBLY by using a sharp tool (Chip IC replacement
tool).
(7) Confirm that the cassette tape is completely wound, and
then peel off the PVC tape from the CASSETTE HOUSING
ASSEMBLY and take out the cassette tape.
NOTE:
To confirm that the cassette tape is completely wound,
confirm that one REEL DISK ASSEMBLY (TU) rotatesFig.5-2-1
as you rotate the other REEL DISK ASSEMBLY (SUP).
(8) Make sure that grease or a similar substance is not
attached to the surface of the tape taken out in the
procedure (7). Similarly, also make sure that grease or a
similar substance is not attached on the MECHANISM
ASSEMBLY, especially the tape transport system.
1-20 (No.YF005) |
ACEC
