3.4 REEL DISK ASSY(SUP)
5 REEL DISK ASSY(TU)(W )4
6 REEL COVER ASSY
NOTE4(W )5
NOTE4:
Be careful not to attach the REEL DISK wrongly. The Sup-4
ply side can be identified by the white color at the center.NOTE5
9
5
NOTE4 ,5(S6 a)
NOTE5:
REEL DISK ASSY
Be careful not to attach the(W )68
REEL DISK wrongly. The(S6 a)WHITEBLACK
(W )610
Take-up side can be iden-
(S6 b)
tified by the black color at
the center.
SUPTU
NOTE :66
Perform the following steps for mounting.NOTE6
1. Move the RELEASE GUIDE back and align the 2 holes
with the pins.
2. Attach the PINCH ROLLER ARM ASSY by aligning the
positions.
3. Attach the SUB DECK
NOTE6
ASSY by aligning the
5
32
positions.
4. Check that the parts
below them are lo-
cated in the correct
positions.46
5. Tighten the 2 screws.
6. Tighten the screw.
7. Attach the 2 SLIT
1, 7RELEASE GUIDEFig. 2-4-5
WASHER parts.
4.7 TENSION ARM ASSY
8 SLANT POLE ARM ASSY
9 TU ARM ASSY
0 SWING ARM ASSY
8
NOTE7
NOTE9
NOTE7:
9
8
When detaching, remove the springNOTE711(P )
of the @ PAD ARM ASSY in ad-NOTE8
7(S )10
vance.
Pay attention to the attachment po-NOTE10SPRING
sition.
10
NOTE8
NOTE8:
Be careful not to lose any parts
(such as a spring).
NOTE9:
Pay attention to theSPRINGNOTE7
mounting position.
NOTE9
NOTE10
TOPSIDE
NOTE0:
When detaching, remove the
screw then remove the SWING
ARM ASSY by pulling it up andFig. 2-4-6
turning it.
2-8 |
ACEC
