1.2 JIGS AND TOOLS REQUIRED FOR DISASSEMBLY,1.3 DISASSEMBLY/ASSEMBLY OF CABINET PARTS
ASSEMBLY AND ADJUSTMENTAND BOARD ASSEMBLY
1.2.1 Tools required for adjustments1.3.1 Disassembly flow chart
Torque driverBitThis flowchart indicates the disassembly step for the cabi-
12
YTU94088YTU94088-003net parts and board assembly in order to gain access to
item(s) to be serviced. When reassembling, perform the
step(s) in reverse order.
1ZOOM OPE UNIT
TweezersChip IC replacement jig
34
P-895PTS40844-22FRONT COVER ASSY
(Inc. FE SW BOARD ASSY,
FRONT BOARD ASSY,
JUNCTION BOARD ASSY,
SHOE ASSY, SW FPC UNIT,
FOCUS UNIT, MICROPHONE)
Cleaning cloth
5
KSMM-01
UPPER CASE ASSY
3
(Inc. @ MONITOR ASSY)
4OP BLOCK ASSY
5DSC BOARD ASSY
Table 1-2-1
1. Torque driver
6REAR COVER ASSY
Be sure to use to fastening the mechanism and exterior
parts because those parts must strictly be controlled for
tightening torque.
7E. VF ASSY
2. Bit
This bit is slightly longer than those set in conventional
torque drivers.8LOWER CASE ASSY
3. Tweezers
To be used for removing and installing parts and wires.
9MAIN BOARD ASSY
4. Chip IC replacement jig
To be used for adjustment of the camera system.
5. Cleaning cloth0
PRE/MDA BOARD ASSY,
Recommended cleaning cloth to wipe down the video/
MECHANISM ASSY
heads, mechanism (tape transport system), optical lens!
surface.
Table 1-3-1
1-2 |
ACEC
