1.2 JIGS AND TOOLS REQUIRED FOR DISASSEMBLY,1.3 DISASSEMBLY/ASSEMBLY OF CABINET PARTS
ASSEMBLY AND ADJUSTMENTAND BOARD ASSEMBLY
1.2.1 Tools required for adjustments1.3.1 Disassembly flow chart
Torque DriverBitThis flowchart indicates the disassembly step for the cabi-
12
YTU94088YTU94088-003net parts and board assembly in order to gain access to
item(s) to be serviced. When reassembling, perform the
step(s) in reverse order.
1COVER(ZOOM) ASSY
TweezersChip IC Replacement Jig
34
P-895PTS40844-2UPPER CASE ASSY
2
(Inc.E.VF UNIT(B/W,COLOR),SPEAKER/MONITOR)
FRONT COVER ASSY
3
(Inc.DC LIGHT,MIC)
Cleaning Cloth
5
KSMM-01OP BLOCK ASSY
4
/BRACKET(OP) ASSY
5REAR UNIT
6LOWER CASE ASSY
Table 1-2-1/ (Inc.ZOOM UNIT)
7/JACK BOARD ASSY
1. Torque driver
Be sure to use to fastening the mechanism and exterior
parts because those parts must strictly be controlled for8JUNCTION BOARD ASSY
tightening torque.
9
2. BitMAIN BOARD ASSY
/
This bit is slightly longer than those set in conventional/MECHANISM ASSY
0
torque drivers.
3. Tweezers!
E.VF UNIT
/
To be used for removing and installing parts and wires./SPEAKER
@
4. Chip IC replacement jig
To be used for adjustment of the camera system.#
MONITOR ASSY
/
5. Cleaning cloth/MONITOR BOARD ASSY$
Recommended cleaning cloth to wipe down the video
Table 1-3-1
heads, mechanism (tape transport system), optical lens
surface.
1-2 |
ACEC
