1.44 MONITOR ASSEMBLY3. Unplug the wires and FPCs from the two connectors ( c ,
d ) and then remove the LCD BL board assembly, holder
1.4.1 Disassembly/assembly of monitor assembly
(PWB) and backlight in that order.
(for 2.5�-type LCD)
4. Remove the LCD module.
Note:Be careful not to soil or scratch the monitor screen
through the disassembly/assembly work.
1. Remove the four screws (1 to 4) in numerical order. While1.4.2 Disassembly/assembly of hinge assembly
disengaging the six hooks (L4a to L4f) in alphabetical(for 2.5�-type LCD)
order, remove the monitor cover assembly.
1. Remove the three screws (5 to 7), and then remove the
Note4a:When removing the monitor cover assembly, be
hinge covers (1) and (2) by disengaging a total of four
careful not to damage the FPC and connector.hooks (L4g, L4h) at the two sides.
2. Unlock the connector b and then disconnect the FPC2. Separate the SW board assembly and the FPC from the
while lifting the hinge assembly upwards to remove it to-hinge assembly.
gether with the FPC.
Note4d:When connecting the FPC, arrange the FPC wire
Note4b:For disconnecting the FPC, unlock the connector
by winding it around the shaft (hinge pin) of the
first and then lift the hinge assembly upwards.
hinge assembly by two and a half turns while pay-
Accordingly, the FPC is disconnected together
ing heed to the orientation of the hinge assembly
with the hinge assembly.
and FPC.
Note4c:Treat the wires carefully.
Note4e:When disassembling/assembling the hinge assem-
bly, pay careful attention to every part not to dam-
age anything.
(L c)4(L f)4
: 0.069N?m (0.7kgf?cm)Monitor cover
(L e)4
: 0.098N?m (1.0kgf?cm)assy
: 0.147N?m (1.5kgf?cm)
(L b)4
Hinge cover(1)2
a(L d)4
3(S a)4
(S b)441
67(S b)44(L a)4
(S a)
(S d)4(S d)4
c
LCD BL PWB
cd
a
MONI. FPC ASSYNote a4
Note d / e44ab
5Note b4
4
(S c)4Note d / e4
Hinge assy
Note d / e44
(L g)4b
FPC
Holder
(PWB)
c(L h)4
Hinge cover(2)
Hinge
Backlight
4LCD moduleNote c
Bracket(Earth)
Monitor case assy
a
Fig. 1-4-1
1-7 |
ACEC
