2.2 DISASSEMBLY/ASSEMBLY OF MECHANISM<SUB CAM GEAR>
ASSEMBLY
2.2.1General statement
The mechanism should generally be disassembled/assem-
bled in the EJECT mode (ASSEMBLY mode). (Refer to Fig.
2-2-1.)
TOP VIEWBOTTOM VIEW
However, when the mechanism is removed from the main body,
it is set in the STOP mode. Therefore, after the mechanism is
removed from the main body, supply 3 V DC to the electrode
on the top of the loading motor to enter the mechanism mode
into the EJECT mode compulsory.<EJECT mode>
<Mechanism assembly/Cassette housing assembly>
DC3V
Fig. 2-2-2
<C IN mode>
Motor
Fig. 2-2-3
<SHORT FF mode>
Fig. 2-2-4
<STOP mode>
<Back side of the mechanism assembly>
Fig. 2-2-5
<REV mode>
Back side of deck
EJECT mode
Fig. 2-2-1
Fig. 2-2-6
2.2.2Explanation of mechanism mode
The mechanism mode of this model is classified into six<PLAY mode>
modes as shown in Table 2-2-1. Each mechanism mode can
be distinguished from others by the relative position of OQ�
mark on the sub cam gear to the inner or outer protrusion
on the main deck.
Refer to Fig. 2-2-2 to 2-2-7 below.
The EJECT mode, C IN mode and SHORT FF mode should
be recognized by the relative position of the OQ� mark to
Fig. 2-2-7
the inner protrusion, while the STOP mode, REV mode and
PLAY mode should be recognized by that to the outer pro-
trusion.
2-2
ACEC
