8.Slit washer installation jig1.3 DISASSEMBLY/ASSEMBLY OF CABINET PARTS
To be used to install slit washers.AND BOARD ASSEMBLY
9.Power supply jig1.3.1 Disassembly flow chart
To be used for power supply to the set when the
This flowchart indicates the disassembly step for the cabi-
exclusive DC power cord is not used. Carefully use
net parts and board assembly in order to gain access to
this jig, especially not to damage the battery terminal
item(s) to be serviced. When reassembling, perform the(+/-).
step(s) in reverse order.
10. Jig connector cable
1DECK OPE ASSY
Connected to CN1010 of the main board and used
for electrical adjustment, etc.
2FRONT COVER ASSY
11. Extension connector
Connect this extension connector to the connector3UPPER CASE ASSY
(INC. MONITOR, etc.)
of the jig connector cable for extending the cable
connector.4MONITOR ASSY
Note:For supplying the power through the coupler
by removing the cover (for jig), use this5BASE ASSY
extension connector double for connecting6LOWER CASE ASSY
the jig connector cable.(INC. OP BLOCK, E. VF)
12. PC cable
7OP BLOCK ASSY
To be used to connect the VideoMovie and a
personal computer with each other when a personal8STROBE ASSY
computer is used for adjustment.
9MIC
13. Alignment tape
To be used for check and adjustment of0E VF ASSY
interchangeability of the mechanism.
-AUDIO VF BOARD ASSY
14. Service support system
=MDA BOARD ASSY
To be used for adjustment with a personal computer.
~MAIN BOARD ASSY
15. INF adjustment lens
To be used for adjustment of the camera system.
!MECHANISM ASSY
16. INF adjustment lens holder
To be used together with the camera stand for
operating the VideoMovie in the stripped-down
condition such as the status without the exterior
parts or for using commodities that are not yet
conformable to the interchangeable ring.
17. Camera stand
To be used together with the INF adjustment lens
holder.
18. Light box assembly
To be used for adjustment of the camera system.
19. Gray scale chart (for Light box assembly)
To be used for adjustment of the camera system.
20. Color bar chart (for Light box assembly)
To be used for adjustment of the camera system.
21. Soldering kit
Thin head is made so that it can be inserted into
small spaces.
22. Cleaning cloth
Recommended cleaning cloth to wipe down the
video heads, mechanism (tape transport system),
optical lens surface.
1-3 |
ACEC
