10.Light box assembly3.3 MECHANISM ADJUSTMENT
To be used for adjustment of the camera system. For the us-
3.3.1 TAPE TRANSPORT ADJUSTMENT
age of the Light box assembly, refer to the Service Bulletin No.
Mechanism adjustment is needed when DRUM ASSEMBLY or a
YA-SB-10035.
part of the tape transport system is replaced. To protect tapes
11.Camera standfrom damage, first clean the tape transport system, next confirm
To be used together with the INF adjustment lens that nothing is wrong with the tape transport systemholder. For by using a
the usage of the Camera stand, refer to the Servitace Bupe thlletinat can be disposed of, and then perform adjustment with
No. YA-SB-10035.alignment tape. Some exterior parts should be removed before
12. Jig connector cable some adjustment procedures, depending on the procedures.
To be connected to the Jig connector jack of the main board
and used for measurement and adjustment.
POLE BASE (SUP)POLE BASE (TU)
MAIN CN25JIG BOARD (LABEL)(GUIDE ROLLER)(GUIDE ROLLER)
AL_L3.2V11AL_L3.2V
TU GUIDE
MCU_RST112BATT+POLE
BATT+23BATT+
A/C HEAD
V_TP_FM124C_OUTASSEMBLY
BATT+35DIAL_PB
V_FF136Y_OUT
C_OUT47GND
TENSIONPINCH
PB_CTL148GND
POLEROLLER
DIAL_PB59GND
REG_4.8V1510V_OVL
Y_OUT611MCU_RST
AO_SIG_J1612V_TP_FM
GND713V_FF
TXD1714PB_CTL
GND815REG_4.8V
RXD1816AO_SIG_J
GND917TXD
JIGCN_SW1918RXD
Fig.3-3-1
V_OVL 1019JIGCN_SW
VPP_7.8V2020VPP_7.8V3.3.2 Back tension
Remove the exterior parts attached to CASSETTE HOUSING
Fig.3-2-2ASSEMBLY so that scales of CASSETTE TORQUE METER can
be read.
13.Communication Cable
Y CASE COVER(S),(M) ASSEMBLY
Connect the Communication cable between the PC cable and
Y C. COVER INSIDE
Jig connector cable when performing a PC adjustment.
14.Service support system
CASSETTE TORQUE METER
To be used for adjustment with a personal computer. Software
can be downloaded also from JS-net.
15.PC cable
To be used to connect the Videocamera and a personal com-
puter with each other when a personal computer issued for ad-
justment.
16.Cleaning cloth
Recommended the Cleaning cloth to wipe down the video
heads, mechanism (tape transport system), optical lens sur-
face.
Fig.3-3-2
(1) Set a cassette torque meter onto the deck and measure the
back tension in standard PB mode to confirm that the back
-3-3
tension is 0.97x10 - 1.71x10 NYm.
(2) If not, replace the tension band.
When the value widely fluctuates in the measurement,
replace the SUPPLY REEL DISK.
(3) With the CASSETTE TORQUE METER, confirm that the
-3-3
play torque is 1.47x10 - 2.45x10 NYm.
If necessary, replace the center pulley unit.
3-3 |
ACEC
