HA-W250RF (J)
10 (No.70244)
HOW TO USEHOW TO USE
1. Connect the transmitter and AV equipment. (Refer to page 9)5. Adjust the volume control of the connected AV equipment and the head-
2. Connect the AC adaptor to the transmitter, then plug the AC adaptor into anphones, and set them to the desired listening level.ENGLISH
AC outlet. (Refer to page 10)6. Push the AUTO TUNING switch control to get the best reception in the
3. Turn on the power on the transmitter and the connected AV equipment.headphones.
Page 10
When the button is pressed, frequency tuning starts automatically and it stops
when a signal is detected.
Note :
Signals not originating from the transmitter or unexpected signals can also cause
the frequency tuning to stop. If this happens, press the button again to resume
tuning.
In cases of interference or too much noise, turn the TUNING control on the
transmitter to another position, then repeat step 6.
To set optimum signal reception, adjustments
should be done within a range of approx. 7 m/23 ft
Transmitter powerbetween the transmitter and the headphones.
When an audio signal is input, the transmitter�s power is turned on automatically, and the
indicator lights in green. Also, when no audio signal is input for about a minute, theWithin approx.
indicator goes out automatically and the power turns off. (Automatic Power On/Off function)7 m/23 ft
In some situations, the power may not be turned on automatically by the input sound
(e.g. a song with a quiet opening or gradual fade-in). This is not a malfunction.
4. Turn on the headphones� power. To avoid excessive volume, first set the
headphones� volume to a low level.
00.9.18, 4:01 PM
Tips for better use
For improved sound quality, set the volume level of the connected equipment as high as
possible without causing distortion, while setting the volume level of the headphones to a
slightly lower level.
"EPCF1BHF.BLFS+11$
After use
Keep the headphones� power off.
Notes:
1. When using the headphones, don�t raise the volume excessively. Continuous
Before using the headphones for the first time, charge the rechargeable Ni-Cd battery.listening for a long time at high volumes may damage your hearing.
2. For safety reasons, do not use the headphones while riding a bicycle or driving a
motorcycle, car, etc.
1415 |
ACEC
