USING THE REMOTE CONTROL UNIT (cont.)
46 EN
SELECT SCENES
Remote sensor
Point the remote control at the camcorderOs remote
4sensor. Press PLAY, then press ON/OFF on the remote
control. The R.A. Edit counter display appears.
Press REW or FF to locate the beginning of the scene
5you want, then press IN/OUT to register that point.
The data appears under OIN� on the display.
Press REW or FF to locate the end of the scene and
6press IN/OUT to register it.
YThe data appears under OOUT� on the display.
YThe total time of the registered scene(s) is displayed
at the bottom of the screen.
Repeat steps 5 and 6 for each additional scene (as
Power Switch7many as 8).
To make corrections, press CANCEL during steps 5
FF8and 6 to erase the most recently registered point.
REW
PAUSE
PLAY
CANCEL
IN/OUTNOTES:
ON/OFFcThere must be at least one second between an in-point
and its corresponding out-point.
RM-V700U
cTo ensure correct operation, there should be at least
(optional)
15 seconds between an out-point and the next in-point.
cBlank portions of a tape cannot be registered as in-points
or out-points.
INOUT
10:00:25--:--:--cIf it takes more than 5 minutes to search for an in-point,
2
3the VCROs Record-Pause mode is cancelled and editing
4does not take place.
5
6cPressing ON/OFF clears all in- and out-points from
7memory.
8
COUNTER0:00:25cLeave a small margin for error around each in-point to
TOTAL0:00:00
ensure the scene is recorded in its entirety.
cTurning off the camcorderOs power erases all registered
INOUTin- and out-points.
10:00:250:01:05
20:03:180:03:31
30:02:330:02:53
40:04:11--:--:--
5
6
7
8
COUNTER0:04:11
TOTAL0:01:13 |
ACEC
