DVR-6100/6100K
CONTENTS / ACCESSORIES / CAUTIONS
Contents
CONTENTS / ACCESSORIES / CAUTIONS............. 2PC BOARD .............................................................. 15
DISASSEMBLY FOR REPAIR....................................3SCHEMATIC DIAGRAM .......................................... 24
BLOCK DIAGRAM ......................................................4EXPLODED VIEW ....................................................36
CIRCUIT DESCRIPTION ............................................5PARTS LIST..............................................................37
WIRING DIAGRAM ...................................................14SPECIFICATIONS ......................................Back cover
Accessories
FM indoor antenna (1)Loop antenna (1)Video cord (1)Remote control unit (1)
(T90-0882-08)(T90-0896-08)(E30-1427-05)(A70-1607-08): KP
(A70-1608-08): YX
(A70-1609-08): ET
(A70-1610-08): MM2H
Speaker cords (6) Batteries (R6/AA) (2) SCART plug adaptor (1)
(E30-7265-08): RED(Europe and U.K. only)*AC Plug Adaptor (1) *
(E30-7283-08): GREEN(E69-0012-05)(E03-0115-05)
(E30-7284-08): BLUE
(E30-7285-08): VIOLETUse to adapt the plug on the
(E30-7269-08): GREYpower cord to the shape of the
(E30-7286-08): WHITEwall outlet.
(Accessory only for regions where
use is necessary.)
Cautions
Caution on condensationMemory backup function
Condensation (of dew) may occur inside the unit when there isStored contents which areAmplifier section
a great difference in temperature between this unit and the out-cleared in at least a week afterLast input selection
side.power plug is unplugged fromVolume control value
This unit may not function properly if condensation occurs. Inpower outlet.Surround setting
this case, leave the unit for a few hours, and restart the opera-ACTIVE EQ
tion after the condensation has dried up.Tuner section
Be specially cautious against condensation in a fol-Receiving band
lowing circumstances:Frequency
Preset stations
When this unit is carried from one place to another across a large
difference in temperature, when the humidity in the room whereTuning mode setting
DVD section
this unit is installed increases, etc.
Menu setup
Power status
Note related to transportation and movement
Before transporting or moving this unit, carry out the
following operations.WARNING NOTICE:
1Remove the disc from the unit.
IN MOST CASES IT IS AN INFRINGEMENT OF COPY-
2Press the 6 key.RIGHT TO MAKE COPIES OF TAPES OR DISCS WITH-
OUT THE PERMISSION OF THE COPYRIGHT OWN-
ERS. ANYONE WISHING TO COPY COMMERCIALLY
AVAILABLE TAPES OR DISC SHOULD CONTACT THE
MECHANICAL COPYRIGHT PROTECTION SOCIETY
LIMITED OR THE PERFORMING RIGHTS SOCIETY LIM-
3Wait a few seconds and turn the unit OFF.
ITED.
Operation to resetThe marking of products using lasers
The microcomputer may fall into malfunction (impossibility
(Except for some areas)
to operate, erroneous display, etc.) when the power cord is
unplugged while power is ON or due to an external factor. In
this case, execute the following procedure to reset theCLASS 1
LASER PRODUCT
microcomputer and return it to normal condition.
Set the POWER switch to ON (set to Standby mode).The marking this product has been classified as Class
Then press the c key, 4 key and STOP key in this1. It means that there is no danger of hazardous radia-
order.tion outside the product.
Location: Back panel
÷ Please note that resetting the microcomputer clears the
contents stored in and returns and to condition when it left
the factory.
2 |
ACEC
