FrameMaker Ver5.5E(PC) 7415 GENERAL
00.07.19
SAFETY AND IMPORTANT WARNING ITEMS
SAFETY WARNINGS
[1] MODIFICATIONS NOT AUTHO-[2] CHECKPOINTS WHEN PER-
RIZED BY KonicaFORMING ON-SITE SERVICE
Konica copiers are renowned for their high Konica copiers are extensively tested before
reliability. This reliability is achieved through shipping, to ensure that all applicable safety
high-quality design and a solid service net-standards are met, in order to protect the cus-
work.tomer and customer engineer from the risk of
injury. However, in daily use, any electrical
Photocopier design is a highly complicated equipment may be subject to parts wear and
and delicate process where numerous eventual failure. In order to maintain safety
mechanical, physical, and electrical aspects and reliability, the customer engineer must
have to be taken into consideration, with the perform regular safety checks.
aim of arriving at proper tolerances and safety
factors. For this reason, unauthorized modifi-
1. Advance Preparation for
cations involve a high risk of degrading perfor-
mance and safety. Such modifications are Safety Checks
therefore strictly prohibited. The points listed CAUTION:
below are not exhaustive, but they illustrate
the reasoning behind this policy.(1) Wear clothing that facilitates work and
is designed for safety.
(2) Carry out all procedures carefully to
PROHIBITED ACTIONS:prevent injury.
(1) Using extension cables or a different (3) Be sure to disconnect the power cord
power cord than specified by Konica.of the copier and all optional equip-
(2) Using other fuses than specified by ment from the AC outlet.
Konica. Safety will not be assured, Simply turning off the power switch is
leading to a risk of fire and injury.not sufficient, because paper feed
(3) Disabling fuses or bridging fuse termi-units or other electrical equipment may
nals with wire, metal clips, solder or be powered also when the power
similar. (This applies also to thermal switch is turned off.
fuses.)(4) Proceed with special care when per-
(4) Removing air filters (except for forming operation checks or adjust-
replacement).ment while the unit is powered. When
(5) Disabling relay functions (such as carrying out operation checks or
wedging paper between relay contacts, adjustment while external covers are
etc.).removed, the risk of electrical shock
(6) Disabling safety functions (interlocks, exists when touching parts which carry
safety circuits, etc.). Safety will not be high voltage or electrical charge. The
assured, leading to a risk of fire and risk of injury exists when touching
injury.moving parts such as gears or chains.
(7) Performing actions to copier not
described in the instruction manual or
the service handbook.
(8) Using parts other than specified by
Konica.
C-2 |
ACEC
