DISASSEMB LY
1. DOOR2. DOOR SWITCH
"Freezer Door1) Use the driver broken the two small cap of the front.
2) Loosen four screws in upper part and disconnect top cover.
1) Loosen 2 screws and pull the Lower Cover.
3) Disconnect Lead Wire from switch.
2) Loosen hexagonal bolts fixing the lower hinge to the body to
remove the freezer door only.4) Disengage hook behind the switch by pressing it with hands.
Lower Hinge
Bolt
Figure 9
Figure 6
3. REFRIGERATOR ROOM LAMP
1) Remove the Cover Lamp, R by pulling with a '' type driver.
3) Pull out the Door Gasket to remover from the Door Foam Assy,
2) Remove the Lamp by turning.
F.
GASKE T
Figure 10
3) After removing the lamp, you must check the O-RING, which is
Figure 7
made by rubber and prevent electric spark, in the socket.
4. DISPLAY
1)Tear the PC SHEET on the cover of the display.(OPTION)
"Refrigerator Door2)Pry the displayms cover from the gap between the display and
1) Loosen hexagonal bolts fixing the center hinge(Hinge,C) to the display cover by using a (-) screw driver. Then pull out the display
body to remove the refrigerator door only. circuit board to replace.
Hinge, C
Bolt
12
Figure 8
2) Pull out the Door Gasket to remove from the
Door Foam Assy, R.
-8- |
ACEC
