Level 3 Service Manual
GALAXY ASTRAL GEO GEO WAP
6.2Software (MTS) installation
This part describes how to install the different components of MTS depending of the functions of MTS
you want to use.
6.2.1 Simple Setup :
If you want to have only the test mode functions (control and adjust RF parameters), follow this
procedure:
? Launch Setup.exe on MTS CD ROM root.
? Select the Custom Setup Type in Setup Type selection window and click onNext >
? Select the component as follow :
aMTS Application
aTestStand Engine
GPIB Software
NI-VISA Software
Internet Explorer
Then continue the setup program until Reboot information window and reboot.
MTS after sale service is now available in y Start, Program, M TS After Sale Service
6.2.2Complete Setup :
If you want to have all the function of MTS (control and adjust the RF parameters, execute and
parameter the autotests), follow this procedure :
? Launch Setup.exe on MTS CD ROM root.
? Select the Typical Setup Type in Setup Type selection window and click onNext >
? Then continue the setup program until Reboot information window and reboot.
MTS after sale service is now available in y Start, Program, M TS After Sale Service
Before you launch an autotest, you must unvalid the step :4301 DIO initialisation
For that you have to turn the Execution mode switch on run selected step in the autotest page.
Mitsubishi Electric Telecom Europe SAVersion E
ZA le Piquet, 35370 EtrellesDate: 04/00
Phone: +33 2 99 75 71 00
21/29
Fax: + 33 2 99 75 71 47 |
ACEC
