DPC-8.5
SERVICE PROCEDURES-1
PROTECTION OF EYES FROM LASER BEAM DURING SERVICING
This set employs a laser. Therefore, be sure to follow
carefully the instructions below when servicing.
WARNING!!Laser Diode Properties
Wavelength: 650/780nm (DVD/CD)
SERVICE WARNING : DO NOT APPROACH THE
LASER EXIT WITH THE EYE TOO CLOSELY.
IN CASE IT IS NECESSARY TO CONFIRM LASER
BEAM EMISSION, BE SURE TO OBSERVE FROM
A DISTANCE OF MORE THAN 30cm FROM THE
SURFACE OF THE OBJECTIVE LENS ON THE
OPTICAL PICKUP BLOCK.
WARNING
WARNING:WARNINGAVIS
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, RISK OF ELECTRIC SHOCKRISQUE DE CHOC ELECTRIQUE
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR DO NOT OPENNE PAS OUVRIR
MOISTURE.
The lightning flash with arrowhead symbol, within
an equilateral triangle, is intended to alert the user to
CAUTION:
the presence of uninsulated "dangerous voltage" within
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
the product's enclosure that may be of sufficient magnitude
REMOVE COVER (OR BACK). NO USER-SERVICEABLE
to constitute a risk of electric shock to persons.
PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
LASER WARNING
This unit contains a semiconductor laser system and is classified
The label on the right
as a "CLASS 1 LASER PRODUCT". So, to use this model
is applied on the rear
properly, read this Instruction Manual carefully. In case of any
panel except for USA"CLASS 1 LASER
trouble, please contact the store where you purchased the unit.
and Canadian PRODUCT"
To prevent being exposed to the laser beam, do not try to open
models.
the enclosure.
CAUTION:
VISIBLE LASER RADIATION WHEN OPEN AND INTERLOCK
FAILED OR DEFEATED. DO NOT STARE INTO BEAM.1.This unit is a CLASS 1 LASER PRODUCT and employs a
laser inside the cabinet.
CAUTION:
2.To prevent the laser from being exposed, do not remove
THIS PRODUCT UTILIZES A LASER. USE OF CONTROLS
the cover. Refer servicing to qualified personnel.
OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES
OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.
LASER BEAM CAUTION LABEL
SERVICE PROCEDURE
1. Replacing the fuses
This symbol located near the fuse indicates that the
fuse used is show operating type, For continued protection against
fire hazard, replace with same type fuse , For fuse rating, refer to
the marking adjest to the symbol.
Ce symbole indique que le fusible utilise est e lent.
Pour une protection permanente, n'utiliser que des fusibles de meme
type. Ce demier est indique la qu le present symbol est apposre.
REF. NO.PART NO.DESCRIPTION
F1015120-0130-0 or1.6A-UL/T-237 <CDD1N>
5120-1000-01.6A-T/UL-ST2 <CDD1N>
<CDD1N> : North American area |