Sensitivity Adjustment (In case of type C Models)
1. Connect the each clips to LISTA cable to test points.
2. Set the adjustment mode according to adjustment heads.
(Refer to [LISTA Adjustment Modes] of the ?Table of Test Point?.)
3. Playback the LISTA Alignment Tape.
4. Select the item ?<6> ATF Error Signal Monitor? on the LISTA main menu, and press the SPACE key for
execute the ?RS232C Connector Check?. Normally the message ?RS232C CONNECTION COMPLETE!!!? and
?ATF GAIN value? appeared on screen. After finish the Connection check, press the ?0? key for download the
adjustment value of ATF GAIN. Next, press the Enter key and displayed real time sensitivity data.
5. The waveform as shown below figure appeared on the screen, press arrow keys on the keyboard of the PC so
that the ?Sensitivity. Value? on the upper right corner of the screen is within specification.
Information 1 : Press the ?Â? or ??? key : The value changes by 1 step.
Press the ??? or ??? key : The value changes by 10 step.
After corrected the data, the screen is disappeared momentary during the calculating on
LISTA software.
Information 2 : The data ?85? appear on the screen before adjustment, but this value is not VTR?s value.
This value is equal to VTR?s value after transmit the data once.
6. After finish this adjustment, press the ESC key to return to the main menu.
Adjust within specification
2-49 |
ACEC
