file:///E:/BT-S1315DA_BT-S1315DAD_BT-S1415DA_BT-S1415DAD/SVC/s0407020000.html
4.7.2 Adjustment Procedure
TOP PREVIOUS NEXT
1. Set the color temperature to "6500K".
2. Fully degauss the front, both sides, and top of the picture tube with an external degaussing coil.
3. Input a crosshatch pattern signal and adjust the convergence by horizontally and vertically
positioning the static convergence magnet and deflection yoke.
4. Change the input signal to a 100% white pattern signal and adjust the BRIGHT and
CONTRAST controls to obtain a digital voltmeter reading of 14.3 V0.8 V.
5. Adjust the purity magnet to obtain a uniform landing at each place of nearly 2 cm from the
right and left screen edges. At this time, if it is difficult to obtain correct purity, finely adjust
the fore-and-aft position of the deflection yokeand its tilt and fine-tune the purity magnet.
Note:
6. When adjusting the purity magnet, first set the adjustment ring with a small dilation and the
other with no dilation to the same position at the top and then adjust them in symmetrical
opposite directions each other.
7. Display a red pattern and check its purity.
8. Display a blue pattern and check its purity.
9. Display the 100% white pattern and check its white quality.
10. If there is a problem in steps 6 through 8, repeat steps 2 through 8 until its problem disappears.
@
TOP PREVIOUS NEXT
file:///E:/BT-S1315DA_BT-S1315DAD_BT-S1415DA_BT-S1415DAD/SVC/s0407020000.html [2006-02-04 08:28:35] |
ACEC
