DISASSEMBLY/REASSEMBLYINSTRUCTIONS
5.2.11 Hinge Removal
1. Open the phone. From the hinge cavity press the retaining lugs on the hinge pins to release the hinge pins. Note that the
hinge pins are different lengths and must be replaced in their original positions.
10641-1
5.3. Reassembly
Reassembly is the reverse of disassembly. However, the following checks should be observed:
All flexible connectors are located and secured correctly.
Roll the connector end of the Flexi-PCB round to enable the excess to be located in the hinge cavity.
Ensure earth springs are in position in the LCD holder.
The vibrate unit contacts are not bent.
The speaker cushion is placed with mesh facing the moulding.
All securing screws are not over-tightened as this may affect the operation of the keypad.
The hinge pins are replaced in their correct sides.
On refitting the four case screws, new grey screw caps are fitted to the screw recesses.
IF ANY OF THE RF OR LOGIC SHIELDS ARE REMOVED FROM THE PCB AT ANY TIME, THEY MUST BE REPLACED BY
NEW ITEMS. ONCE REMOVED, THE SHIELDS MUST NOT BE REUSED.
On completion of reassembly, the handset must be re-calibrated as detailed in Section 8.
PROVISIONAL INFORMATION
MMCD021001C8Section 5Issue B
Service Manual- 25 -Revision 0 |
ACEC
