6109P2 GS3 CM25OSD Lock Function & Service Mode
Go to cover page
To lock (disable) OSD function:Access Service mode (burn in mode) :
- Press OSD button "" for over 15 seconds to lock the OSD function.Access Service Mode & Burn in mode
Release it, then OSD comes on the screen as below.
Firstly, get into Factory Adjustment Mode.
ATTENTIONPush LEFT& RIGHTbuttons at the same time for
over 15 seconds and release them.
CONTROL MENU IS LOCKEDThe factory message appears at the bottom of the
main OSD menu. (for example : 109P V3.08 000601;
00105 isM.T.B.F.inHOURunit)
00105
To unlock (enable) OSD function:
- Press OSD button "" for over 10 seconds again to unlock the
OSD function.
Release it, then OSD comes on the screen as below.
109P V3.08 000601
Disable/Enable all the WARNING SIGNAL
To disable all the WARNING SIGNAL :
-DisconnecttheInterfacecableofthemonitor.
- Push LEFT& RIGHTbuttons at the same time, then power
- Disconnect the Interface cable of the monitor (Monitor is ON.).
ON.
- Press OSD button "" for over 15 seconds to disable all the
WARNING SIGNAL. Then release the "OSD" button.
- If it is successful, the signal ""
- If it is successful, then the signal "NO SIGNAL INPUT"disappeared to
comes on the screen later.SERVICE MODE
enter power saving-off mode.
(Background is white.).SERIAL NO: TY 123456
HOURS : 00021
FACTORY VER 1.01 990706
Exit "burn in MODE" :
- Reconnect the interface cable to PC, then the "burn in MODE"
To enable all the WARNING SIGNAL :
Disappear.
- After disconnect the Interface cable of the monitor, then Monitor is
powered ON.
- If it is successful, the signal "NOSIGNALINPUT" comes on the screen
again later.
BackForward |
ACEC
