[ 14PV111/ ( 01, 07, 58 ), 14PV112/ ( 07, 39 ), 14PV203/ ( 01, 07, 39, 58 ),
14PV415/ ( 01, 07, 39, 58 ), 14PV460/ ( 01, 07, 39, 58 ) ]
General Note:
"CBA" is abbreviation for "Circuit Board How to set up the option code
Assembly."
1. Enter the Service mode.
NOTE: 2. Press the [STATUS/EXIT] button on the remote
control unit. The option code appears on the dis-
Electrical adjustments are required after replacingplay.
circuit components and certain mechanical parts.
It is important to perform these adjustments only3. If needed, input the option code as shown below
using number buttons on the remote control unit.
after all repairs and replacements have been com-
pleted.ModelOption Code
Also, do not attempt these adjustments unless the
proper equipment is available.14PV111(112)(415)/07000128
14PV112(415)/39000129
14PV111(415)/01000130
Test Equipment Required14PV111(415)/58000131
1. PAL Pattern Generator (Color Bar W/White Win-14PV203(460)(465)/01000158
dow, Red Color, Dot Pattern, Gray Scale,
Monoscope, Multi-Burst)14PV203(460)(465)/07000156
14PV203(460)(465)/39000157
2. AC Milli Voltmeter (RMS)
3. Alignment Tape (FL6A), Blank Tape14PV203(460)(465)/58000159
4. DC Voltmeter4. To reset the software, press [PAUSE] and [5] but-
5. Oscilloscope: Dual-trace with 10:1 probe, tons on the remote control unit.
The option code is changed.
V-Range: 0.001~50V/Div,
F-Range: DC~AC-60MHz
6. Frequency Counter
7. Plastic Tip Driver
How to Set up the Service mode:
NOTE:
After replacing the IC202 ( Memory ) or Main CBA,
the set value in IC202 ( Memory ) will be lost. So it
is necessary to set up or adjust in the Service
mode after its replacement.
Service Mode:
1. Turn the power on. (Use main power on the TV
unit.)
2. Press [STANDBY/ON], [2], [7], [1], and [MUTE]
buttons on the remote control unit in that order
within 5 seconds.
- To cancel the service mode, press [STANDBY/ON]
button on the remote control.
1-6-9T6310EA |
ACEC
