2-4
INSTRUCTION FOR USE
ARR
ST STA
O RO
HCRH
C
SYN SYN
CD CD
FM AM1700108104130010010008009863097
BANDFMAM
VOLUME
OFFTAPECDPOWERDBBDYNAMIC BASS BOOSTPOWERDBBDYNAMIC BASS BOOSTOPEN
G
DIN
OR
EC
T R
AR
ST
HRO
FF/TAPE
FF
OO
stations, direct the built-in antenna by turning the whole
stations, pull out the telescopic antenna. To improve the
avoid unnecessary power consumption.
FMMW
Set the POWER slider to FM or MW to select the desired wave band.Tune to the desired radio station by using the TUNING wheel.
BASIC FUNCTIONSRADIOSwitching the set on and offSet the POWER slider to the desired sound source: CD, TAPE, or BAND (for radio).The set is switched off when the POWER slider is set to and the keys of the tape deck are released.Note: If you use batteries, switch the set off after use. This willAdjusting volume and soundAdjust the volume using the VOLUME control.Increase and decrease the bass level by pressing DBB.The bass level can also be emphasised if you place the set against wall or shelf. Do not cover any vents; leave sufficient room around the unit for ventilation.Radio � tuning to radio stations12Improving RADIO reception For signal, incline and turn the antenna. Reduce its length if the signal is too strong (very close to a transmitter).For set. The telescopic antenna is not needed.6
English
English
5
A
POWER SUPPLY
, set this
A
The mains cable is
The type plate is located
-cells (preferably alkaline).
D
or
UM-1
,
R20
Check whether the mains voltage as shown on the type plate corresponds to your local mains voltage. If it does not, consult your dealer or service organisation. on the bottom of the set.If the set is equipped with a VOLTAGE selector selector to the local mains voltage.Connect the mains cable to the AC MAINS socket and the wall socket. This switches on the mains supply. inside the battery compartment.
Batteries (optional)Open the battery compartment of the set and insert 6 batteries, type Remove batteries if they are flat or if the set is not going to be used for a long time.Batteries contain chemical substances, so they should be disposed of properly.Mains123The battery supply will be switched off when the set is connected to the mains. To change over to battery supply, pull out the plug from the unitOs AC MAINSsocket.To disconnect the set from the mains completely, remove the mains plug from the wall socket.For users in the U.K.: please follow the instructions on page2.Environmental informationAll redundant packing material has been omitted. We have done our utmost to make the packaging easily separable into three mono materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packing materials, exhausted batteries and old equipment.
CS 49 105 |
ACEC
