CD-VC50-02
7.2 DIAGNOSIS
7.2.1 TEST MODE
. The system outputs the word, thenxt step.When registration/recognition is failed:
lt of communication to confirm whether
e MODE key is pressed for less than two
connected, the system generates a [Peep].
the words registered in Step 4. The systemseep peep] in Step 5. Repeat Steps 4 and 5.
essing the [-] key is invalid. Sound volume can
??????????????????????????????
Numbers in parentheses indicate order of appearance in Test mode for service (as shown below).
29)English (English)30)French (French)31)German (German)32)Nihongo (Japanese)35) IP-BUS is NO GOOD.
be switched with the LEVEL key as with in normal use.connection of IP-BUS is normal or not. The system answers either "IP-BUS is OK" or "IP-BUS is NO GOOD." If the main set is not generates a [Peep peep]. When four words are registered, the system outputs "Naming is complete," and you may proceed to the neoutputs "Thank you" (if recognition is successful), then generates [Peep peep]. You may repeat this as many times as you wish. [Bee-ee peep], changing from low to high pitch, will be generated, instead of the [Peep peep] in Step 4 and "Thank you" and [Pseconds, the system outputs "TEST MODE" and returns to Step 2.
Starts registration. (Memory mode)1) Input name.8) Entrez le nom.15) Bitte Namen eingeben.22) Touroku sitekudasai.Retries registration.2) Please input name again.9) Entrez le nom a nouveau.16) Bitte erneut eingeben.23) Mouitido.Registration is completed.3) Naming is complete.10) Le nom est enregistre.17) Name ist gespeichert.24) Touroku simasita.Starts recognition. (Call mode)4) Make your request.11) Faites votre demande.18) Bitte aufrufen.25) Rikuesuto wo douzo.Retries recognition.5) Please make your request again.12) Recommencez sOil vous plait.19) Bitte erneut aufrufen.26) Mouitido.Recognition is completed.6) Thank you.13) Merci.20) Vielen Dank.27) Wakarimasita.When a word is too long7) That name is too long.14) Le nom est trop long.21) Name zu lang.28) Nagasugimasu.Registers when Guidance is OFF.37) [Peep]Registration is completed when Guidance is OFF.38) [Peep peep]Recognizes when Guidance is OFF.39) [Beep]Recognition is completed when Guidance is OFF.40) [Beep beep]Retries when Guidance is OFF41) [Bee-eep]Fails when Guidance is OFF.42) [Bee-eep bee-eep]Starts Test mode.33) Test Mode.Checks IP-BUS in Test mode.34) IP-BUS is OK.Ends Test mode.36) Test is finished.
(Outline of Test Mode for Service)Step 1Starting operation: Ground test point SERVICE, then press the RESET switch. The system outputs "TEST MODE."Step 2Confirmation of guidance: The system plays back in order of the numbers shown above every time the [+] key is pressed. PrStep 3Confirmation of IP-BUS connection: When the MODE key is pressed for less than two seconds, the system informs of the resuStep 4Confirmation of registration: Press the MODE key for more than two seconds. The system outputs "Input name." Speak a wordStep 5Confirmation of recognition: Press the MODE key for less than two seconds. The system outputs "Make your request." Speak Step 6End: When Step 4 is completed, press the MODE key for more than two seconds. The system outputs "Test is finished." If thTo return to normal operation: Open Pin 1, then press the RESET switch.
15 |
ACEC
