CX-892
- Removing the Spindle Motor Assy
1. Rotate the tray motor until the clamp joint arm moves.
2. Slide and remove the clamp spring as shown in Fig. 25.
3. Remove the clamper.
4. As shown below, match the positions of the holes of the support wheel and screws F. Then remove the two screws F
and spindle motor assy.
* When removing the clamper, be careful not to lose the ball mounted between the clamper and clamp spring.
Release the clamp spring fromLift here
the hook(s), and then slide it inClamp joint
the direction indicated with anarm
arrow.Clamp spring
ball
Clamper
Clamper
Match the positions of the
holes and screws F.
Screw F
Support wheelSpindle motor assy
Screw F
Fig. 25
- Cautions on Mounting the Spindle Motor Assy
1. Mount the spindle motor assy so that the lead wires face the rear of the mechanism unit (see Fig. 26).
Mechanism unit - bottom viewFront side (magazine insertion port)
Spindle
motor
assyOrientation of the lead wire
Rear Fig. 26
2. Check that the torsion spring presses the side pressure plate (see Fig. 27).
Support wheel
Side pressure plate
Torsion spring
Fig. 27
3. When mounting the clamper, confirm that the ball has been installed.
20 |
ACEC
