5678
- How to hold the Mechanical Unit
1.Hold the top and bottom frame.
2.Do not squeeze top frame's front portion too tight,
because it is fragile.
A
Do not squeeze.
- How to remove the Top and Bottom Frame
B1.When the disk is "clamp" state, unlock Spring A (6Top Frame
pieces) and Spring B (2 pieces), and unscrew screws
(4 pieces).
2.Unlock each 1 of pawl at the both side of the frame,
then remove the top frame.
3.Remove the Carriage Mechanical part in such wayCarriage
that; you remove the mechanical part from 3 piecesMechanicalection and
Part
of Damper while slowly pulling up the part.
4.Now, the top frame has been removed, and under
this state, fix the genuine Connector again, and eject
the disk.
(Caution)
Bottom Frame
When you reassemble the Carriage Mechanical part,
apply a bit of alcohol to Dampers.
C
Damper
- How to remove the Guide Arm Assy
1.Unlock the spring (1 piece) at the right side of the
assembly.
2.Unscrew screws (2 pieces), then remove the ScrewScrew Gear Bracket
Gear Bracket.
3.Shift the Guide Arm Assy to the left and slowly rotateGuide Arm
Assy
it to the upper direction.
4.When the Guide Arm Assy rotates approximately 45
degree, shift the Assy to the right side dir
remove it.
D
DEH-P440/XN/UC49
5678 |
ACEC
