5678
6.5 ERROR MODE
- Error Messages
If a CD is not operative or stopped during operation due to an error, the error mode is turned on and cause(s) of A
the error is indicated with a corresponding number. This arrangement is intended at reducing nonsense calls from
the users and also for facilitating trouble analysis and repair work in servicing.
(1) Basic Indication Method
1) When SERRORM is selected for the CSMOD (CD mode area for the system), error codes are written to DMIN
(minutes display area) and DSEC (seconds display area). The same data is written to DMIN and DSEC. DTNO
remains in blank as before.
2) Head unit display examples
B
Depending on display capability of LCD used, display will vary as shown below. xx contains the error number.
8-digit display6-digit display4-digit display
ERROR-xxERR-xxE-xx
(2) Error Code List
Code ClassDisplayed error code Description of the code and potential cause(s)
10Electricity Carriage Home NGCRG can't be moved to inner diameter.
SERVO LSI Com-CRG can't be moved from inner diameter.
munication Error? Failure on home switch or CRG move mechanism.
C
Communication error between microcomputer and SERVO LSI.
11Electricity Focus Servo NGFocusing not available.
? Stains on rear side of disc or excessive vibrations on REWRITABLE.
12Electricity Spindle Lock NGSpindle not locked. Sub-code is strange (not readable).
Subcode NG? Failure on spindle, stains or damages on disc, or excessive vibrations.
A disc not containing CD-R data is found.
Turned over disc are found, though rarely.
CD signal error.
17Electricity Setup NGAGC protection doesn't work. Focus can be easily lost.
D? Damages or stains on disc, or excessive vibrations on REWRITABLE.
30Electricity Search Time OutFailed to reach target address.
? CRG tracking error or damages on disc.
44Electricity ALL SkipSkip setting for all track.
(CD-R/RW)
50MechanismCD On Mech ErrorMechanical error during CD ON.
? Defective loading motor, mechanical lock and mechanical sensor.
A0SystemPower Supply NGPower (VD) is ground faulted.
? Failure on SW transistor or power supply (failure on connector).
Remarks: Mechanical errors are not displayed (because a CD is turned off in these errors).E
Unreadable TOC does not constitute an error. An intended operation continues in this case.
Upper digits of an error code are subdivided as shown below:
1x: Setup relevant errors, 3x: Search relevant errors, Ax: Other errors.
F
DEH-P8MP/XN/UC
61
5678 |
ACEC
