DRM-6NX
Problems When Accessing Disc ChangersWeb Browser
To restore the defaults settings using a Web browser:
Disc changer flutter can occur if a user requests access
to a CD-ROM when another user is already reading data1. Start the Web browser.
from another CD-ROM. The changer may then attempt2. Click Administration.
to service both requests by repeatedly changing3. Click PIONEER Changer.
between the two CD-ROMs and transferring a small4. Click Factory Defaults.
amount of data each time. Because of the relatively long
The factory default setting will now be restored and the
time needed to change CD-ROMs, the data transfer
DRM-6NX will then automatically restart.
rate to both users will become unacceptably low.
FTP
The JukeBox Lock Time parameter in the DRM-6NX
To restore the default settings using FTP:
configuration file specifies how long a user has exclusive
access to a CD-ROM during a data read operation. This1. Log in to the DRM-6NX with the command:
is to prevent disc change flutter in order to optimizeftp <host name>, where <host name> is the name assigned
access speed when many users are accessing differentin your system host table.
discs in the same changer.2. You will be prompted for user id and password. Use
The JukeBox Lock Time parameter will ensure thatthe user id root, which has the default password pass
when there are simultaneous requests for access to(root is the user id with the highest priority).
different discs, a sizable block of data is transferred to3. Restore the default setting with the command:
each user before the access is changed.get defaults
The unit will then automatically restart.
� If the JukeBox Lock Time parameter is set too low,4. Log out using any of the commands quit, bye or exit
the data transfer rate will be unacceptably low.depending on your FTP version.
� If the JukeBox Lock Time parameter is set too high,
the disc drive will time-out on a second userOs requestReset Button
before the first userOs access is completed. This willTo restore the default settings using the Reset button:
result in users receiving a �CD-ROM not availableO
notice.1. Turn off the DRM-6NX.
2. Press and hold the Reset button while you switch on
The default setting is 0 seconds which disables this
the DRM-6NX. Keep the Reset button pressed until
function.
the Network indicator flashes at regular two second
intervals.
NOTE:
7 If some drive error occurs during caching/reading,Caching/Reading is
canceled and the drive and discs become disable.
Only restarting this product cam clear this condition.
Restoring Factory Default Settings
If required, you can restore the factory default settings
to your DRM-6NX , e.g. if you have disabled all network
protocols. You can use any of these methods:
� Web browser
� FTP on a TCP/IP network
� Reset button
Step by step instructions for each method are givenReset button
below.
NOTES:
3. Release the Reset button and wait at least two
7 The node address, the Hardware Address parameter, will remain
unchanged, but all other parameters will be restored. You will thus needseconds (one flash of the Network indicator).
to re-assign the Internet address to re-establish the Web browser4.Press and hold the Reset button for at least five
connection.
seconds until the Network indicator remains
constantly lit.
7 All Cached data in the HDD is cleared when restoring the factory default
setting.5. Turn off the DRM-6NX. And switch on the DRM-6NX
again.
The factory default setting will now be restored.
50 |
ACEC
