1234
7.1.10 DISASSEMBLY
Note: Even if the unit shown in the photos and illustrations in this manual may differ from your product, the procedures
described here are common.
A
Diagnosis of the DVDM Assy
1Bonnet and Tray panel
1Remove the bonnet by removing the seven screws.
22 6Press the STANDBY/ON button to turn on the
power.
3Press the 0button to open the tray.
4Remove the tray panel.
BPress the 0 button to close the tray.
5
6Press the STANDBY/ON button to turn off the
power.
4
Tray35
3
5
C
Tray panel
How to open the Tray when the power cannot be on
Insert a screwdriver (small) into the slit located at the bottom of the
unit, and slide the projection of the drive cam in the 04 LOADER
Assy in the direction of the arrow, as indicated in the photo. If the tray
pops out a little, fully pull it out by a hand.
D
Screwdriver (small)
Projection
Slit
Drive cam
E
04 LOADER Assy
Tray open
F
Screwdriver (small)
62DV-373-S
1234 |